Media Blasting Versus Chemical Stripping

MEDIA BLASTING

Although media blasting can be accomplished by a homeowner, it does not lend itself well to a do-it-yourself project since it requires the rental of an industrial-size air compressor as well as the Blaster Buddy unit. Although the objective of media blasting is to strip off the existing finish, it also removes the top layer of wood in the process. Since media blasting can be a very aggressive procedure, in the hands of someone inexperienced with media blasting, a lot of damage can be done to the surface of the wood in a very short period of time. That’s one reason that media blasting is best left in the hands of professionals who have had some prior experience. In general we take the position that media blasting should be considered carefully and evaluated as a secondary method, rather than the preferred method of removing an existing finish. We often receive calls from homeowners who are virtually in tears after seeing what media blasting did to their beautiful log home. They call us wanting to know what they can do to restore the logs to their original smooth surface. The sad news is that the only way to restore the surface is lots of hand sanding. Of course, when properly accomplished by an experienced individual who knows what they are doing, media blasting followed by Osborn brushing can result in a fairly smooth surface. However, this is more the exception than the rule.

SOME ADVANTAGES OF MEDIA BLASTING

• Does an excellent job removing most paints and stains
• Fairly quick and cost effective
• Avoids water getting into the home, but dry dust and blasting media will most likely penetrate into the interior of the home
• Since the blasting media consists of either recycled crushed glass, or organic materials like corncob grit or walnut shells, there is little chance of well or water contamination

DISADVANTAGES OF MEDIA BLASTING

• Media blasting changes the surface characteristics of the wood
• In addition to roughening the surface, it increases the surface porosity
• Many people consider a media blasted surface unattractive and the only way to restore the wood to a smooth surface is with lots of hand sanding 
• Prelude™ should ALWAYS be used as a primer on media blasted surfaces
• Having enough blasting media on hand is critical. You don’t want to run out in the middle of a wall since it may take two or three days to have additional material shipped to your location

CHEMICAL STRIPPING

Chemical stripping refers to the use of finish removers used in conjunction with a pressure washer. Since chemical strippers only soften an existing finish, they must be used along with a pressure washer to actually remove the finish from the wall. As opposed to media blasting, chemical stripping is much more user-friendly since all it takes is a general purpose pressure washer (available at most do-it-yourself outlets or equipment rental locations) and either our S-100™ or StripIt® Finish Removers.

A pressure washer is quite a bit easier to handle than media blasting equipment, and although aggressive pressure washing can still do some surface damage, it’s fairly easy to fix with a light sanding or an Osborn Buffing Brush.

The main advantage of chemical stripping is that the use of proper procedures can result in a beautiful, smooth, clean surface. So why do some stain manufacturers recommend media blasting over pressure washing? Media blasting significantly increases the porosity of the surface, thus giving an inferior finish better adhesion since the rough surface gives the finish more surface area to grab onto.

SOME ADVANTAGES OF CHEMICAL STRIPPING

• Does an excellent job when correct procedures are used
• User-friendly. Takes little expertise and no special equipment is required
• One wall can be refinished at a time
• Results in a more attractive surface

DISADVANTAGES OF CHEMICAL STRIPPING

• Water will get into the home
• Need to protect plants and shrubs from chemicals
• May take more than one application to completely remove an existing finish
• Must thoroughly rinse any applied chemicals before applying finish